<?xml version="1.0" standalone="yes"?>
<!-- 
===========================================================
This file contains options for exporting a flat Pattern
to a DWG/DXF file.
In this version the only option is to replace splines with 
line segments with a set chord tolerance.

enable="1" will turn the option on
enable="0" will turn the option off

chord_tolerance sets the maximum distance from any point 
on the line to the spline. 
Please use '.' as decimal delimiter.

===========================================================
-->

<!--
===========================================================
                     BEGIN DTD SECTION
Do not modify the DTD section of this file.  It is used to
verify that the content of the file is valid.
===========================================================
-->
<!DOCTYPE fpdwgEdits [
   <!ELEMENT fpdwgEdits      (option)>
   <!ELEMENT option         (replace)>
   <!ELEMENT replace         (spline, advlegacyexport?)>
   <!ELEMENT spline         EMPTY>
   <!ELEMENT advlegacyexport   EMPTY>
   
   <!ATTLIST fpdwgEdits version CDATA #REQUIRED>
   <!ATTLIST spline enable CDATA #REQUIRED>
   <!ATTLIST spline chord_tolerance CDATA #REQUIRED>
   <!ATTLIST advlegacyexport enable CDATA #REQUIRED>
]>
<!--
===========================================================
                      END DTD SECTION
===========================================================
-->
<fpdwgEdits version='1.0'>
   <option>
      <replace>
         <spline enable="1" chord_tolerance="0.01" />
         <advlegacyexport enable="1" />
      </replace>
   </option>
</fpdwgEdits>
